I bought the license for MPG2 and WVC1 codecs, but I am unsure on how to install it. My config document seems wrong (Below is what my config document says on my micro sd card). I have been unable to install via Putty.

For more options and information see

http://www.raspberrypi.org/documentation/configuration/config-txt.md

Some settings may impact device functionality. See link above for details

uncomment if you get no picture on HDMI for a default "safe" mode

hdmi_safe=1

uncomment this if your display has a black border of unused pixels visible

and your display can output without overscan

disable_overscan=1

uncomment the following to adjust overscan. Use positive numbers if console

goes off screen, and negative if there is too much border

overscan_left=16

overscan_right=16

overscan_top=16

overscan_bottom=16

uncomment to force a console size. By default it will be display's size minus

overscan.

framebuffer_width=1280

framebuffer_height=720

uncomment if hdmi display is not detected and composite is being output

hdmi_force_hotplug=1

uncomment to force a specific HDMI mode (this will force VGA)

hdmi_group=1

hdmi_mode=1

uncomment to force a HDMI mode rather than DVI. This can make audio work in

DMT (computer monitor) modes

hdmi_drive=2

uncomment to increase signal to HDMI, if you have interference, blanking, or

no display

config_hdmi_boost=4

uncomment for composite PAL

sdtv_mode=2

uncomment to overclock the arm. 700 MHz is the default.

arm_freq=1000

Uncomment some or all of these to enable the optional hardware interfaces

dtparam=i2c_arm=on

dtparam=i2s=on

dtparam=spi=on

Uncomment this to enable the lirc-rpi module

dtoverlay=lirc-rpi

Additional overlays and parameters are documented /boot/overlays/README

Enable audio (loads snd_bcm2835)

dtparam=audio=on
core_freq=500
sdram_freq=500
over_voltage=2